Support at your plant: material and curing equipment

Naltek helps you choose the material and the curing equipment that fit your product’s requirements and evaluate the process around them. UV dose measurement, process set-up and trials on your line are services we quote per inquiry.

What we do

Material choice
We screen the Bectron® range and the VFP inks against your requirements and send you a property comparison with the datasheets.
Process evaluation
Cost, process time and line speed for the material, its application and its cure, looked at together.
Datasheet review
We read the TDS of the materials on your line with you: cure window, mix ratio, pot life, storage.
Dispensing and curing advice
Which application method suits which material, and what the lamp or oven has to deliver.
UV dose
Calculated from lamp type, lens, working distance and belt speed, or measured on your line on request, and compared with the window in the material’s datasheet.
Set-up, trials, troubleshooting
On your line.
R&D
We take an active part in development discussions with our suppliers on custom projects and materials.
How a visit runs

How a visit runs

Hoenle UV Scan reader with macsStrips dose strips
Hoenle UV Scan meter and dose strips. Image: Hoenle AG
  1. 1

    Before the visit you tell us what is protected, bonded or potted, the requirements in your own numbers, the application method and equipment, the cure available, volumes and timeline.

  2. 2

    At the line we look at the dispensing and curing equipment and at the datasheets of the materials in use, and measure the UV dose if you want it.

  3. 3

    We agree the pass and fail criteria with you before any sample is shipped.

  4. 4

    After the trial we go through the results with you and give a recommendation.

How we work, case by case

Matching a material to the requirements

For a potting job we screen the Bectron® range against the plant’s own requirements, such as operating temperature, vibration protection, thermal conductivity, hardness and the viscosity its dispensing needs.

An equivalent for another maker’s material

When a plant asks for an equivalent to another brand’s material, we offer the closest options for the property that matters most and ask to involve the plant’s R&D team.

The material and the dispensing line

Before a two-component potting material is ordered in pails, we check that the pail fits the pump the plant prefers. For dispensing trials we record the equipment and the parameters (material pressure, dispensing speed, needle diameters), so the manufacturer answers with data.

Cleaning the line

When a plant asks which cleaner to use on its polyurethane dispensing equipment, we take the question to the manufacturer and come back with the options it confirmed and the safety data sheet.

A coating that stays tacky

When a heat-cured coating stays tacky after the oven, we check with the plant whether the parts reach the cure temperature, the shelf life of the batch and how the material is handled. We take the batch question to the manufacturer; in one such case it recommended smaller packs.

Line problems · UV dose calculator · Supply chain

Tell us about your line

Tell us what you need. We reply within 24 hours, in Romanian or English.

What do you need?

The button opens your email program with the inquiry filled in; you send it from there. We use these details only to answer this inquiry. Privacy notice

Contact directly

Alexandru Nichifor
Sales & technical support

+40 771 709 622

nichiforlx@nalteksolutions.com

Naltek Solutions S.R.L.
Sat Comori, Com. Gurghiu, nr. 81, jud. Mureș 547298