Which application method suits each Bectron® material

This note is application know-how: which application method suits which material, so the coating, the potting and the cure work together on your line.

Three-step dam and fill: a needle dispenses a dam bead around a component on a circuit board, then fills it with encapsulant
Image: ELANTAS Europe
Tab. 1Application method by material
ApplicationBectron® materialsApplication method
Conformal coating
Thin film, selective PL 4122-40, PL 1102, PT 4700 N, PL 4122 range Selective spray or film-coating valve on a coating robot
Thick film, selective PT 4600, PT 4601, PK 4340 Bead or film dispensing; PT 4600 cures under UV, shadow areas by moisture
Melting resins MR 3402, MR 3405, MR 3406 Heated hot-melt application at the temperature the TDS gives
Potting and encapsulation
2-component polyurethane PU 4501, PU 4522 Meter-mix-dispense with static mixer, at the TDS mix ratio
2-component silicone gel SG 75V1-15, SG 75V1-60, SG 75V1-75 Meter-mix-dispense; low viscosity flows into gaps
2-component epoxy EP 5502, EP 5504 Meter-mix-dispense with static mixer
1-component heat-curing polyurethane PK 4344 Volumetric 1-component dispensing, then oven cure
Dam and fill
Dam PT 4606 High-viscosity volumetric bead around the area
Fill PK 4342, PT 4600 Lower-viscosity fill inside the dam

UV-curing materials need a matching lamp and dose. See the worked example.

Ask for a sample, a TDS, a quote or a dose calculation

Tell us what you need. We reply within 24 hours, in Romanian or English.

What do you need?

The button opens your email program with the inquiry filled in; you send it from there. We use these details only to answer this inquiry. Privacy notice

Contact directly

Alexandru Nichifor
Sales & technical support

+40 771 709 622

nichiforlx@nalteksolutions.com

Naltek Solutions S.R.L.
Sat Comori, Com. Gurghiu, nr. 81, jud. Mureș 547298